51FXLOOPRETURNLEFT
52 FXLOOPSEND
53AUXILIARYINPUT
54MIDITHRU
55MIDIIN
CAUTION:
56 POWER SUPPLY FOR THE ENGL MIDI FOOTCONTROLLER
Please read and heed:
Connect the left FX Loop input to a signal processor's left channel output/send jack
using the shortest possible shielded cord equipped with 1/4" plugs. Activate and
deactivateit viatheStereoFXLoop (17)button.Inthesignal path,the
is located post channel Volume controls and and pre the Master control and the
outputdriverstage.
Connect this output to a signal processor's input/return jack using the
shortestpossibleshieldedcordequippedwith1/4"plugs.Activateanddeactivateitvia
the FX Loop Active (17) button. In the signal path, the is located post
channelVolumecontrolsandpretheMastercontrolandtheoutputdriverstage.
This is the preamp's ancillary input. The circuit is wiredin series with the input located
on the front panel. Use it to connect the preamp to a 19" rack setup. The front panel
inputhas priority. Inother words, whenyouinsert a pluginto the frontpaneljack (1),
thesignalroutedinviatheAux.Inputiscutoff.
This 5-pin DIN port patches incoming MIDI data from the (55) to any other
connectedMIDIdevice.
This 5-pin DIN port accepts data sent by a MIDI sender (for example, the ENGL MIDI
Z-12, Z-15,or Z-9foot controllers) or from orrouted throughanother MIDI device.
Switch no. 56 lets you activate the preamp's power supply if you have an ENGL MIDI
footcontrollerconnectedtothisport.
Before you connect any other MIDI footswitch or effects device, always
makesurethatswitchno.56issettotherighttoavoiddamagingthedevice.
This selector activates a MIDI In port power supply for connected ENGL MIDI foot
boards.Power isfedtothe boardviatheMIDIcircuit.Whentheswitchissettotheleft
position,power is routedto theMIDIIn port's pin1 andpin2 (refer to page30for pin
assignments). If you choose to use another MIDI foot board, be sureto set theswitch
totherightto avoid damaging it. If thefootboardyouareusingisdesignedtohandle
phantom power, consult its operating manual to learn how it is wired (that is, which
pins carry its power supply) and what its voltage and current specifications are. If the
voltageandcurrent specificationsandwiringmatch,youmay settheswitchtotheleft
topowerthisfootboardviatheMIDIcable.
Note that a MIDI foot board may not draw more than 200
milliamperes of current if you want to power itvia this port. You must also check and
verify if this MIDI foot board is able to handle 11 volts of alternating current (AC)! If
you are in any doubt, be sure to consult a specialist, meaning an amp technician or
electronicsengineerwhoearnsalivingwithascrewdriver!
StereoFX Loop
FX Loop
Stereo FX Loop
MIDI In
18
(37 Seiten)
(35 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern