8 Treble-Clean
9 Treble-Crunch
12 Power Tube Monitor V1
13PowerTubeMonitorV2
for Channel 1 (Clean
mode).
for Channel 2 (Crunch
mode).
Determines the level of Channel 1 (Clean mode). Twist this knob to adjust Channel 1's
volume and dial in the desired balance of levels with Channel 2, 3 and 4. Because this
volume control is located pre effects loop, it also determines the effects send level for
Channel 1. The green LED to the right of the knob lights up to indicate Channel 1 is on.
Determines the level of Channel 2 (Crunch mode). Twist this knob to adjust Channel 2's
volume and dial in the desired balance of levels with Channel 1, 3 and 4. Because this
volume control is located pre effects loop, it also determines the effects send level for
Channel 2. The yellow LED to the right of the knob lights up to indicate Channel 2 is on.
This LED lights up when the current flowing through the V1 power amp tube was too
high and the power tube monitor system has switched that tube off.
To learn more about this crucial protection feature, read the paragraph that follows
section 15. See the tube layout chart on page 22 to locate V1's position on the amp
chassis.
This LED lights up when the current flowing through the V2 power amp tube was too
high and the power tube monitor system has switched that tube off.
To learn more about this crucial protection feature, read the paragraph that follows
section 15. See the tube layout chart on page 22 to locate V2's position on the amp
chassis.
This is the preamp voicing section's passive high-frequency EQ
This is the preamp voicing section's passive high-frequency EQ
To help you get acquainted with the amp's fundamental sounds, I recommend that
you set all tone controls to the center or 12 o'clock position. For higher-gain Crunch
sounds, your best bet is to turn the respective Treble knob (9) well down to prevent the
pickups and speakers from interacting at hi levels and generating feedback (the
recommended setting is somewhere in the 10 to 1 o'clock range).
Bear in mind that you also have the Bright (4) button and the Presence (16) control
knob at your disposal for shaping the high frequency range.
The Clean and Crunch channels are equipped with dedicated Treble knobs (8 & 9). This
means that you can tweak the top end of each of the two channels separately to suit
your taste and the given sonic scenario. You will find that grittier tones generally
sound better with a touch less treble because preamp saturation makes higher
frequencies figure more prominently in the signal.
A tip from the designer:
10 Clean Volume-1
11 Crunch Volume-2
8
(28 Seiten)
(37 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern